Command Communications ComSwitch 8500-t Bedienungsanleitung PDF herunterladen (Seite 19)

Turn Distinctive Ring Detection ON

1. Plug a single line touch-tone telephone into the PHONE port of the CS8500-t

2. Pick up the telephone handset (the PHONE LED will light)

3. Unplug power, then plug back in

4. The FAX LED will light to indicate access to the programming mode

5. Press

(the TTY/TDD port will flash three times acknowledging your

changes)

6. Enter additional changes (if desired)

7. Press again to end programming mode; the FAX LED will turn off

8. Hang up the phone

Turn Distinctive Ring Detection OFF

1. Plug a single line touch-tone telephone into the PHONE port of the CS8500-t

2. Pick up the telephone handset (the PHONE LED will light)

3. Unplug power, then plug back in

4. The FAX LED will light to indicate you are in the programming mode

5. Press

(the TTY/TDD LED will flash three times acknowledging your

changes)

6. Enter all other additional changes (if desired)

7. Press again to end programming mode; the FAX LED will turn off

8. Hang up the phone

Contact Customer Service at 303-792-0870, toll-free 1-800-288-6794 or visit our Web site at

www.commandcommunications.net for more information.

Voice Mail and Distinctive Ring

To automatically route your calls to your TTY/TDD or FAX, and allow Voice Mail and all extension

phones to ring normally, program the CS8500-t as follows:

1. Plug a single line touch-tone telephone into the PHONE port of the CS8500-t

2. Pick up the telephone handset (the PHONE LED will light)

3. Unplug power, then plug back in

4. The FAX light will illuminate to indicate access to the programming mode

CS8500-t Operator’s Guide 1

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Command Communications ComSwitch 8500-t Bedienungsanleitung Seite 19